Instructions:
1. print onto thick cardstock.
2. cut out pieces.
3. poke holes at joints with a pin or needle.
4. using a wire with a small coil at the end, add 1 bead, push through the head and neck joint so that the wire sticks out of the back.
5. add a bead after the second piece and make a small coil in the wires.
6. flatten coil against back of doll. Pinch both coils together to flatten against doll and tighten joint.
7. repeat for all joints.
CLICK AND PRINT....AND PLAY!!!!!
4 comments:
Well now I can finally use my old tooth brush and spray blood on it !
Holy shit, that's awesome.
clever boy!...
everybody come buy shit from sean at FALLCON tomorrow.
www.mncba.com
man...im reading a webcomic...im too LAZY
Post a Comment